Hole-flanging of metals and polymers produced by single point incremental forming

UM > Faculty of Science and Technology

Status	已發表Published
	Hole-flanging of metals and polymers produced by single point incremental forming
	Valentino, A. M. C.; Silva, M. B.; Wong, P. K.; Tam, L. M.; Martins, P. A. F.
	2015
Source Publication	International Journal of Materials and Product Technology (SCI-E)
ISSN	1741-5209
Pages	37-48
Abstract	This paper presents recent developments in hole-flanging of metal and polymers produced by single point incremental forming (SPIF) to gaining insight into the deformation mechanics of the process and providing guidelines to foster its application in rapid prototyping and small batch production of customised sheet products. Experimentation with stainless steel AISI 304L and polyethylene terephthalate (PET) that comprised mechanical characterisation and utilisation of circle grid analysis in conjunction with the formability limit diagram gives support to the presentation and allows understanding the fundamentals of plastic flow and failure in hole-flanging produced by single point incremental forming and their main differences to hole-flanging produced by conventional pressworking.
Keyword	Hole-flanging Single point incremental forming Formability Metals Polymers
Language	英語English
The Source to Article	PB_Publication
PUB ID	22339
Document Type	Journal article
Collection	Faculty of Science and Technology
Corresponding Author	Valentino, A. M. C.
Recommended Citation GB/T 7714	Valentino, A. M. C.,Silva, M. B.,Wong, P. K.,et al. Hole-flanging of metals and polymers produced by single point incremental forming[J]. International Journal of Materials and Product Technology (SCI-E), 2015, 37-48.
APA	Valentino, A. M. C.., Silva, M. B.., Wong, P. K.., Tam, L. M.., & Martins, P. A. F. (2015). Hole-flanging of metals and polymers produced by single point incremental forming. International Journal of Materials and Product Technology (SCI-E), 37-48.
MLA	Valentino, A. M. C.,et al."Hole-flanging of metals and polymers produced by single point incremental forming".International Journal of Materials and Product Technology (SCI-E) (2015):37-48.

Files in This Item:
There are no files associated with this item.

If you have any objections to this item, please fill out the form below and the administrator will contact you as soon as possible.
Content:
Email：	*
Affiliation No.
Verification Code:	Refresh

Any comments and suggestions are welcomed.
Title:	*
Content:
Email：	*
Verification Code:	Refresh