Friction surfacing of AISI 904L super austenitic stainless steel coatings: Microstructure and properties

UM > Faculty of Science and Technology > DEPARTMENT OF ELECTROMECHANICAL ENGINEERING

Status	已發表Published
	Friction surfacing of AISI 904L super austenitic stainless steel coatings: Microstructure and properties
	Guo, D.W.; Kwok, C. T.; Chan, S.L.I.; Tam, L. M.
	2021-02-25
Source Publication	Surface and Coatings Technology
ISSN	0257-8972
Pages	126811----
Abstract	Microstructure, texture, pitting corrosion resistance and hardness of surfaces and cross-sections of the friction surfaced (FSed) super austenitic stainless steel 904L coatings fabricated at various spindle speeds were investigated. The microstructure of the coatings was governed by both dynamic recovery (DRV) and continuous dynamic recrystallization (cDRX) owing to the high stacking fault energy (SFE) of 904L. The grain orientations in DRV were in A2* shear texture component, while the rotated cube textures were related to the cDRXed grains. Immersion tests of the FSed coatings in 3.07 mol/L Cl􀀀 solution showed that the corrosion pits were slightly preferred to generate at the {111} DRVed grains on the coating surfaces, since these grains were likely to have a higher elastic strain during FS. Compared with AISI 304, the pitting potential of the FSed coatings in 3.5 wt% NaCl solution was significantly shifted to nobler direction and also insensitive to spindle speed owing to the high SFE of 904L. However, the passive films of the FSed coatings were thinner and more difficult to reform, as evidenced by slightly larger average pit diameters and lower protection potentials owing to the high residual stress caused by FS.
Keyword	Friction surfacing Super austenitic stainless steel Pitting corrosion Hardness
Language	英語English
The Source to Article	PB_Publication
PUB ID	58754
Document Type	Journal article
Collection	DEPARTMENT OF ELECTROMECHANICAL ENGINEERING
Corresponding Author	Kwok, C. T.
Recommended Citation GB/T 7714	Guo, D.W.,Kwok, C. T.,Chan, S.L.I.,et al. Friction surfacing of AISI 904L super austenitic stainless steel coatings: Microstructure and properties[J]. Surface and Coatings Technology, 2021, 126811----.
APA	Guo, D.W.., Kwok, C. T.., Chan, S.L.I.., & Tam, L. M. (2021). Friction surfacing of AISI 904L super austenitic stainless steel coatings: Microstructure and properties. Surface and Coatings Technology, 126811----.
MLA	Guo, D.W.,et al."Friction surfacing of AISI 904L super austenitic stainless steel coatings: Microstructure and properties".Surface and Coatings Technology (2021):126811----.

Files in This Item:
There are no files associated with this item.

If you have any objections to this item, please fill out the form below and the administrator will contact you as soon as possible.
Content:
Email：	*
Affiliation No.
Verification Code:	Refresh

Any comments and suggestions are welcomed.
Title:	*
Content:
Email：	*
Verification Code:	Refresh